obd2tools
ArchivesTech 2 Connection to Techline TerminalAt times the Tech 2 will need to be connected to a terminal. Reasons for connection to a terminal include the following: * Transfer of vehicle data (calibration information, “snapshot,” etc.) from the Tech 2 to the terminal Before connecting automotive diagnostic equipment Tech 2 to the terminal, the following steps should be taken: * Make sure the appropriate power supply is connected to the DLC cable power jack connector, or to the * Make sure the PCMCIA card is fully inserted into the upper slot at the top of the Tech 2. * Make sure the CANdi module is not connected to the Tech 2. NOTICE
http://obd2lily.nation2.com/tech-2-connection-to-techline-terminal by obd2tools on 2018-02-19 10:00:49 |
Blog Home Archives |