obd2tools
ArchivesRun Subaru Variable Compressor break-in Drive Cycle with SSM3Car: Subaru 10 LGT, 08 & 12 forester, 06 legacy RIP Problem: The compressor on my 2010 grenaded a few month ago. The variable ac compressor only has a pulley, no clutch. I replaced it, the ac condenser and the expansion valve. It still won’t come on. I hooked mine up to Subaru SSM3 scanner and when I command the ac solenoid or try to run the relearn procedure – it fails and says the compressor is in ‘protect mode’ I can’t find anything in the FSM about ‘protect mode’ or what triggers it. No codes present in the AC module I managed to get 72 PSI into the system by heating the can of Freon with a propane torch and then closing the lowside port. Pressure switch shows 58 MPa and does fluctuate with temperature. Shows a commanded evap core temperature as well as actual. Solution: Looks like installing a new compressor requires using the SSM III to run a variable compressor break-in drive cycle. Also – it notes that when you install a new compressor, you need to fill the system with refrigerant before starting the vehicle – if the vehicle is restarted without filling the system, it says to replace the compressor! by obd2tools on 2020-09-25 10:17:22 VXDIAG C6 – DoIP Fix for DTS Monaco enet cable DTSI have seen a few people struggling with DoIP and VXDIAG C6. Please see the attached image of the interface settings for DoIP. When using DoIP with Vxdiag make sure you uncheck/turn off the CAN interface(MODULE_TYPE_ID_MTS6532) in DTS. Then connect the interface to the car and laptop, open vxmanager and turn on DoIP for BENZ. Then open DTS and with the project you require and you will see DoIP ECU available in bottom right corner. If in DTS it shows the DoIP available but no commands work, turn ignition off of vehicle, unplug vci from vehicle and computer, then plug everything back in while rebooting DTS and it should work I don’t find Vxdiag C6 as stable as original eCOM so only use this if you have to. You can also make enet cable work for DoIP for DTS but it is not as stable. Vxdiag C6 use USB! Enjoy! by obd2tools on 2020-09-25 10:06:24 How to selectchange diagnostic tool in TIS2Web for MDI2GM has recently updated the Service Programming System (SPS) with a new method of selecting a J2534 tool in TIS2Web. Selecting a Diagnostic Tool The first time the J2534 Tool option is selected, a screen will appear asking the user to select a device type, such as the MDI, MDI 2 or other tool. Changing a Diagnostic Tool Selection – Thanks to Chris Henley by obd2tools on 2020-09-10 10:28:52 Compare Autel Maxisys Pro with Autel Maxisys Elite Diagnostic Scan ToolThe Autel Maxisys is the fastest scan tool ever in the market. It is built for professional mechanics, technicians, and busy car repair shops. But with so many Autel scanners to choose from, deciding the best OBD2 scanner for your needs can be quite challenging. And if you are confused between the Autel Maxisys Elite and Autel Maxisys Pro, then this post for. In this Autel Maxisys Pro VS Elite review, we’ve compared two of the best Autel Maxisys Professional diagnostic scanners.
by obd2tools on 2020-09-10 10:10:13 |
Blog Home Archives |