Archives

2020

Netgear AC1200 WiFi Extender Setup Guide

Compact in size, Netgear AC1200 WiFi range extender can quickly fill almost every dead network spots present in your home or workplace. It is powered by dual-band wireless technology, experience up to 1200Mbps speed.

Just complete the Netgear AC1200 WiFi range extender setup and enjoy the boosted WiFi. It is followed up by MU-MIMO technology, which allows seamless streaming to all connected devices. This article is the ultimate guide if you are looking for the Netgear AC1200 setup. So, let's begin with it!

Netgear AC1200 Setup Methods

There are two primary methods to set up Netgear AC1200 WiFi range extender, they are:

1. Using Netgear Installation Assistant

2. WPS (Wireless Protected Setup) Method

Netgear AC1200 Extender Setup Using Installation Assistant

1. Place your Netgear WiFi range extender near to your home router. Make sure they both are placed 1-3 feet apart from each other.

2. Plug-in your WiFi range extender to an electric power outlet.

3. Wait until the power LEDs on both the devices turn solid green.

4. Connect your WiFi range extender to home WiFi router using an Ethernet cable.

5. Wait for a few minutes, and then turn on your computer or laptop.

6. Launch any of your preferred web browsers. Our recommendation try Google Chrome for Windows OS or Linux OS and Safari for iOS or MAC devices.

7. Type 'mywifiext' in the address bar and click on the search icon or hit the 'Enter' key.

8. You land on the Netgear extender setup web page.

9. Enter the default Netgear extender login credentials.

10. Hit on the 'Log In' button.

11. You are prompted to the Netgear extender setup interface.

12. Choose the 'Extender' mode.

13. Follow the on-screen instructions to configure your WiFi range extender.

14. Once done, hit on the 'Save' button.

15. Unplug your WiFi range extender, and then place it to another room, where you are facing low or no WiFi signal range.

16. Now, try to connect your computer or laptop to the extended network.

17. Run any web browser and visit your favorite website to test if the Internet connection and speed.

Netgear AC1200 Extender Setup Using WPS (Wireless Protected Setup) Method

1. Try to place your WiFi range extender near to your home WiFi router.

2. Plug it into an electric power outlet and wait until the power LED turns green.

3. Now, press the WPS button present at the side panel of the extender device.

4. Now, unplug the WiFi range extender and place it to a new location.

5. Connect your desktop or laptop to the extended network.

6. Press the Windows + R key. The 'Run' Dialog box will pop-up on your screen.

7. Type 'CMD' and press the enter key.

8. Now, type 'IP config' and again press the enter key.

9. Search for the default gateway. If it is 192.168.1.250, then you have successfully set up your WiFi range extender.

Wrap Up

Does our article prove worthy to you? Please share your valuable feedback with us. If still a few queries are left in your mind related to the Netgear AC1200 extender setup, feel free to ask us. Drop your questions in the comment section. We try to revert it with the best solution.

by hazelsmith on 2020-08-12 12:20:36